|
Order by:
Available to:
eBay Affiliate Links
|
Buy It Now
Condition: New Location: Saint Charles, United States Professional Rubber Roof: Complete Installation Kit- 2.500 sq.ft. First Rate Materials- Black 45Mil EPDM Rubber& Latex Bonding Adhesive Quality Products- ... moreIncludes Seam Tape. Flashing Tape, Primer, Caulk, T-Bars Additional Freight Charges Will Apply- Call for Shipping: 1-888-895-4465 Included Items 10' x 100' 45Mil EPDM Rubber Roofing Roll 15' x 100' 45Mil EPDM Rubber Roofing Roll 8 count 4 Gallon Pails Latex Bonding Adhesive 2 count 3" x 100' Black Seam Tape 2 count 1 Gallon Can Seam Primer/Activator 4" x 50' Black Eternabond Flashing Tape 20 count 10' x 1" Aluminum T-bars(Roofing Edge Termination Bars) 10 Tubes Black Lap Sealant Roofing Caulk Method of Applying EPDM with heavy bodied latex bonding adhesive and 3” seam tape application as required. 1 Clean the roof surface of all shingle debris and nails. Re-fasten any loose roof boards. 2 Fill any gaps larger than 3/8” inch with wooden strips. The EPDM cannot span gaps of more than 3/8" without risk of possible adhesion issues. 3 Start at the bottom of the roof and roll out the EPDM from one side of the roof to the other and let it sit for 10-15 minutes. Fold bottom half of the membrane onto the top half of the in place membrane· 4 Apply the bonding adhesive to the exposed roof deck and NOT to the EPDM membrane as the adhesive is to be applied as a one surface WET LAMINATE using a notched trowel to spread the adhesive in a pattern over the decking. Slowly fold the EPDM roofing membrane back into place while the adhesive is still wet. To ensure adhesive transfer and a good bond. Use a stiff bristled push broom and force the membrane into contact with the adhesive on the roof deck. Repeat the process on the other half of the EPDM membrane. 5 Roll out the next piece of membrane. Allowing a four to six inch overlap on the piece below it. This overlap is crucial to allow enough overlap between the two pieces and to allow the water to flow from the upper part of the roof down to the roof edge. This is also to al
Buy It Now
Free Shipping Condition: New Location: Saint Charles, United States This is latex bonding adhesive to adhere the EPDM or TPO rubber to the roofing insulation or substrate. This is a latex based single surface bonding adhesive ... morewith coverage of about 400 sq. ft. per pail.
|
|
|