|
|
Order by: Available to: eBay Affiliate Links
|
Free Shipping Condition: Used Location: Yorktown Heights, United States Extender card for 7000 series mainframes & plugins, with integral BNC cables for high-speed signals.Appears complete and in good physical conditionNot ... moretested
Buy It Now
Free Shipping Condition: Used Location: Tiverton, United States Item is untested. Pulled from a working environment
Buy It Now
$31.25 Shipping Condition: For parts or not working Location: Tampa, United States Compatible with all Tektronix 7000 Series. Compatible with all Tektronix 7000 Series.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7A13 Differential Comparator. Seems to still work fine. Since I have/had several, photos may not ... morebe of the one you'll get, but any I would send you will reflect your monetary generosity.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7A29. These were made from 1979 to 1992, costing thousands. Seems to still work. Since I have/had ... moreseveral, photos may not be of the one you'll get, but any I would send you will reflect your monetary generosity.
Buy It Now
Condition: For parts or not working Location: Antioch, United States Most scope probes you may already have should work with this scope.
Buy It Now
$36.77 Shipping Condition: For parts or not working Location: Lewisville, United States An optional component, theP7001 Processing Unit, can be added to a 7704A between the acquisition unit and the display unit. The Acquisition Unit of the ... more7704A, the P7001 Processor, and the Display Unit of the 7704A are connected by the Acquisition-Processor-Display (APD) Interface shown below.
Buy It Now
$28.88 Shipping Condition: For parts or not working Location: Lewisville, United States The Tektronix A7704 Acquisition Unit is part of a modular oscilloscope in the 7000 series that takes two 7000-series vertical plug-ins and two 7000-series ... morehorizontal plug-ins. The 7704A has a special modular construction.
Buy It Now
$113.99 Shipping Condition: Used Location: Carmichael, United States You will also receive a Tek P6106 x10 250MHz probe. A grey hook clip is included with it, along with the original ground clip. The slope trigger polarity ... moreswitch is a bit funky but it works. However, mixed and intensify sweep work, as seen in photos.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7A26. 7A26 can be used in any 7000. Seems to still work fine. Since I have/had several, photos ... moremay not be of the one you'll get, but any I would send you will reflect your monetary generosity.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7A18. 7A18 can be used in any 7000. Seems to still work fine. Since I have/had several, photos ... moremay not be of the one you'll get, but any I would send you will reflect your monetary generosity.
Buy It Now
$88.42 Shipping Condition: For parts or not working Location: Rocklin, United States you are bidding on a Tektronix 7603 Scope working well. This unit was droped by UPS and dammaged the CRT. but only minor chips and a crack in the face ... moreplate of the crt will be ok as long as you don't drop or bang the scope like UPS. this scope is not waranteed at all, AS IS, as seen by the pictures the scope works ok, the Modules do not come with the scope, i do not have enough to go around, you can bid on this acording to what your getting, the 7603 Mainframe is the only thing in this auction, if you want Moduls just ask, maybe there is somthing i can do,thanks for looking and have a nice day and abetter day today and a better day tomorrow.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7A19. These were made from 1972 to 1981, costing thousands. Seems to still work fine. Since I have/had ... moreseveral, photos may not be of the one you'll get, but any I would send you will reflect your monetary generosity.
Buy It Now
$16.67 Shipping Condition: Used Location: Lewisville, United States TheTektronix WR501 is a 16-channel word recognizer plug-in for theTM500 system. Note that DL15 and DL115, the 24-pin delay lines that fit in the sockets ... moreon each board are only found on units that were interconnected to an LA 501.
Buy It Now
$35.00 Shipping Condition: Seller refurbished Location: Kaufman, United States WE are including a copy of the manual and parts list and 2ea spare used 200-0950 connector covers as they are no longer available from Tektronix.THESE ... moreARE REQUIRED FOR THE EXTENDER TO WORK PROPERLY. The unit is in.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7B80. 7B80 can be delayed by a 7B85. Have/had several so photos may or may not be of unit you'll ... moreget. The more generous you are the nicer the unit you'll get.
Buy It Now
Free Shipping Condition: For parts or not working Location: West Sacramento, United States Tektronix 7603 Oscilloscope Assy. w/ 7D20 Dual Channel Programmable Digitizer. The Tektronix 7603 is a general-purpose 100 MHz non-storage, large-screen ... morescope that takes two 7000-series vertical plug-ins and one 7000-series horizontal plug-in.
Buy It Now
$13.15 Shipping Condition: For parts or not working Location: Antioch, United States At BUY IT NOW, you get a nice (physical condition) Tek 7B85. 7B85 can be used to delay a 7B80. Have/had several so photos may or may not be of unit you'll ... moreget. The more generous you are the nicer the unit you'll get.
|
|
|
|
(2) Tektronix 7A26 200MHz 2-CH Amplifier Plugins 7000 W/Manual For Parts, Repair
Here is a pair of Tektronix 7A26s. One only triggers on channel one. The other locks up the mainframe. Therefore they will be offered AS-IS, for parts or repair. They are in good cosmetic condition with a few marks on the top and sides from sticker removal, as shown in the photos. These would make a great winter project for any skilled technician or TEK 7000 user. Only the two Tektronix 7A26s and instruction manual with schematics are included in this auction. No mainframe. Cables or other plugins. Details of a WORKING 7A26. THESE ARE NOT PROPERLY WORKING: The 7A26 200MHz Amplifier Plug-In is a dual trace plug-in which offers 5 operating modes. Trigger-source selectability, and trace identify. Vertical sensitivity of 5 mV/div to 5 V/div and with appropriate mainframe, DC to 200MHz bandwidth over the entire range. Also include a 20MHz bandwidth ... morelimit switch which reduces noise in lower-frequency applications. The 7a26. A dual trace plugin amplifier, is the basic building block for three or four trace operation. It features constant bandwidth for all deflection factors. It has 5 operating modes: CH1, CH2, ALT, CHOP, ADD) trigger source selection(Ch1, CH2, Mode. Bandwidth may be set at full or limited to 20Mhz. Features: Bandwidth: DC to 200 MHz. Input Impedance: 1MegOhm 2% 20pf. See our ebay store for more great deals. Many loads. Attenuators, cables, manuals and other equipment available. Click here to Be sure to sign up for our Ebay Newsletter under the'Email Subscriptions' heading for special ebay-only offers. Questions/ Contact We are available 8.30 am to 5.00 pm Eastern Time and respond quickly to all email questions. Shipping or Payment questions? email Technical questions? email Can't wait for an email? Call us at 410 871 2273 You can fax payment information to us at 410 871 1255 Our Mailing Address: Ridge Equipment Company. Inc 2002 Bethel Road Suite 105 Finksburg. MD 21048 Payment We accept American Express/ Visa/ Master Card/ Discover Directly. Or. Pay me securely with any major cre
|
|
|
One Lot Tekronix 7000 Plugins, 7A19, two 7A26, 7D12, 7D15, Counter, 7B87 & more
I am cleaning up and decided to sell my Tek 7000 series plugin in one shot. There are 8 modules. There are two 7A26. Cal Fixture Signal Standardization(067-0587-02) 7D12, 7D15, 7B87, 7A19, 225 MHz counter plugin. These units were bought and mostly tested but have been put away for awhile. One of the 7A26s is got a broken knob. Buyer pays for shipping plus a $10 packaging fee. These units are sold as is no returns accepted.
|
|
 |