|
|
Order by: Available to: eBay Affiliate Links
|
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
$200.00 Shipping Condition: Used Location: Benton, United States 17 1/2 Hughes TCI button drilling bit . With large center hole. 7 5/8 API Reg pin. Sealed bearing good tight seals
Buy It Now
Free Shipping Condition: New Location: Ogden, United States New - Out of box. 24.7" Length. Stamping Cross Coupling Protection ESP Cable Protector.
Buy It Now
Free Shipping Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Mifflinburg, United States
Buy It Now
Condition: Used Location: Mifflinburg, United States Put this piece of drilling history back to work on your cable tool. length, 40" stroke, looks like 3"x4" API pin to box taper tool threads (see. ).
Buy It Now
Condition: Used Location: Lewisburg, United States Located in Mifflinburg, PA USA.
Buy It Now
$36.40 Shipping Condition: New – Open box Location: Coffeyville, United States OUTER BODY ASSEMBLY. EASY ASSEMBLY. DOUBLE THREADED ENDS. APPROXIMATE WEIGHT: 17 LBS. FOR OIL WELL, CAN BE ATTACHED IN GROUND. LENGTH : 25".
Buy It Now
Condition: Used Location: Glassboro, United States 10-3/4" Shank Length. Small orders are no problem. Your Best Work Starts Here™. Lot# 11501 F.Yard.
Buy It Now
$10.00 Shipping Condition: Used Location: Coffeyville, United States TAURUS WELLHEAD ADAPTER, FEED THROUGH LOWER CONNECTOR, 42-031-01A 10315 DI TAURUSWELL HEAD ADAPTER LOWER CONNECTORPART NO. : 42-031-01A 10315 DIMODEL ... moreNO. : 42-038-01ASERIAL NO. : 42-031-01A 10315 DI.
Buy It Now
$199.30 Shipping Condition: New Location: China
Buy It Now
Free Shipping Condition: Used Location: Blackwell, United States Sold As Is.
Buy It Now
Condition: Used Location: Lewisburg, United States Cable Tool Well Drilling Fishing Sub Adapter, tool joint 2-1/2” X 3-1/2” API box female & 2-1/4” X 3-1/4” API pin male threads both appear to be good, ... morejust might need cleaned and greased.
Buy It Now
Condition: Used Location: Glassboro, United States
Buy It Now
Free Shipping Condition: New – Open box Location: Blackwell, United States May be dusty/greasy from storage. I bought most of the parts inventory. I have 1000’s of parts. Gaskets,hardware,gears,shafts,etc. Sold As Is.
Buy It Now
Free Shipping Condition: New – Open box Location: Blackwell, United States May be dusty/greasy from storage. I bought most of the parts inventory. I have 1000’s of parts. Gaskets,hardware,gears,shafts,etc. Sold As Is.
Buy It Now
Free Shipping Condition: New – Open box Location: Burley, United States
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Mifflinburg, United States
Buy It Now
$200.00 Shipping Condition: Used Location: Benton, United States 13 3/4 Hughes sealed bearing. TCI button bit.
Buy It Now
Condition: Used Location: Mifflinburg, United States
Buy It Now
$40.15 Shipping Condition: New Location: Chino Hills, United States
Buy It Now
Condition: New Location: Tomball, United States
Buy It Now
$148.85 Shipping Condition: New Location: Paducah, United States New 7 7/8 TCI button.
Buy It Now
Condition: Used Location: Mifflinburg, United States 9-1/4" cable tool drill chisel bit for water well rig appears to be 2-1/4" x 3-1/4" or 2-1/2" x 3-1/2" API pin thread.
Buy It Now
Condition: Used Location: Mifflinburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States Used - Spudder Rig Cable Drilling Tool to cut drill around broken stem or stuck tooling in well hole for fishing, around 110" overall length.
Buy It Now
$239.44 Shipping Condition: Used Location: Paducah, United States 11 7/8” mill tooth sealed bearing. All seals are perfect. This bit is like new . Has medium to hard drilling. 6 5/8 reg pin
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Free Shipping Condition: New – Open box Location: Ogden, United States Long Well Plunger Part, 23-PO-AR50 Flowco. See pictures. Message me with any questions. Local pickup in Utah is accepted by seller. See pictures to see ... moreactual part you will receive. New, unused as shown in the photographs. Message me with any questions.
Buy It Now
$65.00 Shipping Condition: For parts or not working Location: Houston, United States OIL WELL DRILL BIT. PAPERWEIGHT, DOOR STOP, Water Oil Gas Well Drilling Bit Up for auction I am offering a small“Oil Well Drill Bit” great for yard art– ... moreI make flowers out of them. Also good for paper weight. Door stops and conversational item for a man cave. Threads are clean– appear to have had a gentle life, likely lightly used. Weighs approximately 10 pounds, stands approximately 6 ½ inches tall and 4 ½ inches in diameter. I have clear coated for rust protection. I ship within USA only– lower 48 states. Let me know if you have any questions. I package items very well for safe arrival. Have tried my best to describe item– please closely examine images for accurate judgment. If I have miss represented information– send me information and I will add to posting. Please pay within 48hrs of Auction ending. I will ship within 2 working days of receiving payment. Thanks for Looking. a;06d2.RcmdId ViewItemDescV4,RlogId p4%60bo7%60jtb9%3Fuk.rp73%28%3Ea%3B06d2-146090d1d79-0x110-
Buy It Now
Condition: New Location: Tomball, United States Swivel Joint Long Radius 2" Style 10 M X F Union Ends 10000 PSI Fig 1502 Sour Service Designed for the Critical Service Conditions that Exist in ... moreFracturing. Cementing, Acidizing& Well Testing 1502 Union Ends Enable Fast& Easy Make-Up Has Extra Long Radius Elbows for Better Flow Characteristics Manufactured Specifically for High Pressure Applications, Field Repairable& Easy to Use, Tri-Race Ball Bearing Swivel Joint is Matched to Load Capacities& Service Conditions, All Ball Races are Either Flame Hardened or Snap-In Stainless Steel, Buy this Swivel Joint to ensure long and dependable service. Even in the most extreme conditions!
Buy It Now
Condition: Used Location: Lewisburg, United States 3 1/4" X 4 1/4" A.P.I.
Buy It Now
Free Shipping Condition: New – Open box Location: Blackwell, United States May be dusty/greasy from storage. I bought most of the parts inventory. I have 1000’s of parts. Gaskets,hardware,gears,shafts,etc. Sold As Is.
Buy It Now
Condition: Used Location: Mifflinburg, United States
Buy It Now
$200.00 Shipping Condition: Seller refurbished Location: Benton, United States 13 3/4 TCI tricone bits. All seals are good. With 6 5/8 api reg pin.
Buy It Now
$40.15 Shipping Condition: New Location: Chino Hills, United States
Buy It Now
$163.61 Shipping Condition: Used Location: Mifflinburg, United States
Buy It Now
$255.35 Shipping Condition: Seller refurbished Location: Benton, United States RERUN HAMMER BIT. QL120 SHANK, 17-1/2" HEAD, CONCAVE FACE, DOMED BUTTONS
Buy It Now
$11.60 Shipping Condition: New Location: Bath, United States NEW Square D Pressure Switch FREE FIRST CLASS SHIPPING TO ANYWHERE IN THE U.S.A Use: Submersible or Jet Pump 115v or 230v Model: 9013FSG2J24 Pressure ... moreSettings: Factory Set at 40/60 Can be easily adjusted to 30/50 20/40 or any other setting. Has separate differential adjustment to raise or lower cut out pressure without changing cut in pressure. Important: Air Charge in pressure tank should be set to 2-4 PSI below cut-in pressure of switch to achieve maximum drawdown of tank and avoid short cycling of pump. The higher the pressure setting is set at will lower the overall drawdown capacity of the pressure tank will be. Failure to adjust the air charge properly can cause the following problems: Air Charge too Low: Pump will cycle frequently because the pump will come on before tank is drawn down. Air Charge too High: Tank will draw down completely and pressure will drop off before the pump kicks back on. If your switch is short cycling(rapidly turning on and off) it is probably due to the fact that your pressure tank is failed and is not a switch malfunction. Always check the air charge in the tank with a tire pressure gauge with the pump off and water pressure drained from the lines. Connection: 1/4" FEMALE PIPE THREAD If buying a single switch it will be shipped without box to reduce shipping weight. International Buyers- Please Note: Import duties. Taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying.
Buy It Now
$117.54 Shipping Condition: Seller refurbished Location: Lafayette, United States YOU ARE BIDDING ON A RERUN 7 7/8" R30P REED BUTTON BIT. IADC CODE: 537 4 1/2 API REGULAR CONNECTION WE HAVE OVER 10.000 TRICONES IN STOCK AND READY ... moreTO SHIP. ALL SIZES AND TYPES AVAILABLE. WE ARE A WORLD WIDE SALES AND SERVICE DEALER AND A FULL SERVICE MACHINE AND WELDING SHOP. WE CUSTOM BUILD ANY SIZE HOLE OPENERS, REEMERS, STABILIZERS, SUBS, DRILL COLLARS, AND SUB ADAPTERS. EVERYTHING IS BUILT IN OUR SHOP FROM START TO FINISH. NO WORK IS HIRED OUT, WHICH GREATLY CUTS DOWN ON TIME AND COST TO THE BUYER. VARIOUS SHIPPING METHODS AVAILABLE, INCLUDING OVERNIGHT AND DELIVERY. SAME DAY SHIPPING IN MOST CASES; WE ALSO EXCEPT VISA AND MASTERCARDS; FEEL FREE TO CONTACT US, BY EMAIL OR BY CALLING(618)435-5000(ASK FOR RICK) OR(618)927-5586, WITH ANY QUESTIONS YOU MAY HAVE. WE ARE ALWAYS GLAD TO HELP! OR YOU CAN CHECK OUT OUR WEBSITE FOR MORE PICTURES AND INFORMATION. THANK YOU. RLCBIT. If you are outside of the United States and would like to purchase an item from us please contact me. We have removed international selling due to an overwhelming number of non-paying customers outside of the US. Sorry for any inconvenience.
Buy It Now
$59.67 Shipping Condition: Seller refurbished Location: Greenville, United States Part number: "G" 401381000. Nice well plunger. They look great. No score marks. Hard faced and centerless ground. Threads look fine. They look ready to ... moreuse. See photos.
Buy It Now
Condition: Used Location: Lewisburg, United States Located in Mifflinburg, PA USA.
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
$187.06 Shipping Condition: Used Location: Roseburg, United States 9 7/8" Mill Tooth Bit. Used. Retipped, has some wear on the shanks. Cones are very tight, seals are still very nice. HDD, Vermeer, Ditch Witch, or ... moredown hole Oil/Water/Gas drilling. We carry many other sizes and types of bits as well. Sub adapters. Hole Openers/Rock Reamers, Stabilizers, Fly Cutters and Much more! If you have any questions give us a call. We will be happy to assist you any way we can! 618) 439-7253 Shipments outside the USA. Please ask for freight cost adjustment. Flat shipping costs do not apply outside continental 48 US States. Posted with
Buy It Now
Condition: Used Location: Mifflinburg, United States Used - 23" length cable tool chisel bit 7-1/2" wide should fit inside 8".
Buy It Now
Condition: New – Open box Location: Glassboro, United States Small orders are no problem. Lot# 10518 Pilgrim.
Buy It Now
$65.00 Shipping Condition: New – Open box Location: Draper, United States
Buy It Now
Condition: Used Location: Mifflinburg, United States Used - 5-1/2" cable tool chisel bit 47-48" long 2-1/4" x 3-1/4" thread.
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: Used Location: Lewisburg, United States Used - 24" length cable tool chisel bit 5" wide for drilling inside well casing with spudder rig.
Buy It Now
Condition: Used Location: Lewisburg, United States
Buy It Now
Condition: New Location: Tomball, United States Swivel Joint Long Radius 2" Style 10 M X F Union Ends 15000 PSI Fig 1502 Standard Service Designed for the Critical Service Conditions that Exist ... morein Fracturing. Cementing, Acidizing& Well Testing 1502 Union Ends Enable Fast& Easy Make-Up Has Extra Long Radius Elbows for Better Flow Characteristics Manufactured Specifically for High Pressure Applications, Field Repairable& Easy to Use, Tri-Race Ball Bearing Swivel Joint is Matched to Load Capacities& Service Conditions, All Ball Races are Either Flame Hardened or Snap-In Stainless Steel, Buy this Swivel Joint to ensure long and dependable service. Even in the most extreme conditions!
Buy It Now
Free Shipping Condition: New – Open box Location: Fort Hill, United States This is a new ("never been used") DTH hammer bit, manufactured by the Rockmore Bit Manufacturing Company. It is a Sanvik Mission SD6/ shank. This DTH ... morehammer bit size is 7 7/8 inches. It has 8 splines on the shank and 2 blow/air holes on the convex face. The insert/buttons are the spherical type, made of Tungsten Carbide, a total of 24 on the face, 10 of which are on the gauge. The weight is approximately 73.5 pounds with the Blow Tube in place. The alpha-numeric data imbedded on the shank is "ROCKMORE.Price includes eBay commission, sales tax and shipping.
Buy It Now
Condition: Used Location: Lewisburg, United States
|
|
|
|